The 9th International Conference on Surface Engineering (ICSE 2024)

85 / 2024-09-28 16:45:18

Microstructure and Properties of Particle-Reinforced Inconel 625 Coatings by Wire-Powder Synergistic High-Speed Laser Cladding

high-speed laser cladding,wire-powder synergistic,Inconel 625,carbide particles,wear resistance,corrosion resistance

Two particle-reinforced Inconel 625 coatings were prepared via wire-powder synergistic high-speed laser cladding. In this process, Inconel 625 was employed as the feeding wire, while B₄C and Cr₃C₂ particles served as the feeding powders. The phase composition and microstructure of the two coatings were analyzed, and the microhardness, wear resistance, and corrosion resistance of the two coatings were evaluated. The results indicate that the main phase in both coatings is γ-Ni. The microstructure of both coatings is fine and dense, with segregation of Nb, Cr, Mo, and C elements at the grain boundaries, which indicated precipitation of the Laves phase. Moreover, unmelted Cr₃C₂ particles were observed in the middle of the Inconel 625+Cr₃C₂ coating. The microhardness distribution of both coatings is uniform, with the Inconel 625+B₄C coating exhibiting a higher microhardness than the Inconel 625+Cr₃C₂ coating. The Inconel 625+B₄C coating showed better wear resistance. Both coatings showed passivation during the electrochemical test, the Inconel 625+Cr₃C₂ coating showed better corrosion resistance. In conclusion, the Inconel 625+B₄C coating showed better wear resistance than the Inconel 625+Cr₃C₂ coating, which showed better corrosion resistance.